Standard Electric Jack Plate (up to to 40hp)

Not Sure? Click Here to Find the Right Jack Plate for Your Motor

The Standard Electric Jack Plate fits if:

• Outboard motor weighs 180 lbs or less
• The mounting bracket is 10 ¾ inches wide or less
• Your motor is 8-20 hp, with or without:
  • Factory trim and tilt
  • Manual tilt gas shock assist
• Your motor is 25-40 hp and does not have: 
  • Factory trim and tilt
    
  • Manual tilt gas shock assist

Important: Your motor must meet all three requirements: weight, mounting-bracket width and horsepower/tilt configuration.

Not Compatible with:

• 25–40 hp motors with factory power trim and tilt or manual tilt gas shock assist
• Motors weighing more than 180 lbs
• Motors with mounting brackets wider than 10 ¾ inches

If your motor meets any of these conditions, you will need the Large Unit.

Not Sure? Confirm Your Fit With Our Jack PLate Finder Quiz

Included with Your Jack Plate

• Standard jack plate housing
• On The Fly electric actuator
• Up/down switch
• Relay harness
• 10 feet of wiring from the electric actuator to the battery
• Easy-to-follow DIY instructions

Key Benefits

• Push-Button Adjustment: Raise or lower your motor in seconds using the included switch.
• Better Shallow-Water Access: Lift your motor to help navigate shallower areas.
• Performance Flexibility: Fine-tune your motor height for different loads and water conditions.
• Potentially Reduced Drag: Proper motor height may improve handling, speed, and fuel efficiency.
• Added Propeller and Lower-Unit Protection: Raising the motor can help reduce exposure to underwater obstacles.
• Durable Construction: Built from high-quality, marine-grade aluminum for dependable use in demanding marine environments.
• Load Balancing: Adjust motor height to achieve optimal boat balance and weight distribution, enhancing overall efficiency.